Filter
Top Products
19
TIMER RECORDING
Information
On ShowView
With ShowView, timer programming is greatly simplified
because each TV programme has a corresponding code number
which your recorder is able to recognise.
NOTE:
“Guide Prog. Number” (GUIDE PROG) refers to the assigned
TV station numbers, according to broadcast area, for ShowView
timer recording.
IMPORTANT
Perform the following procedure after the channel setting steps
on pages 5 and 29 – 30, and after the Clock Set procedure on
page 7.
After setting the Guide Prog. Numbers, the station names and
channel positions may be incorrect if you stored or skipped
channels. In this case, re-perform Guide Prog. Number setting.
6
q
12
45
3
6
8
0
7
9
1
3
2
OK
NUMBER
CH SET
CANCEL
Guide Prog. Number Set
MAKE LIST OF STORED
STATION NAMES AND
CHANNEL POSITIONS
1
(Ex.)
ACCESS CH. SET MODE
MENU SCREEN
2
Press and hold CH SET for over 2 seconds. The
Language screen appears. Press OK to access the Ch.
Set Mode Menu screen.
SELECT MODE
3
Press PUSH JOG
%
fi
to
place the pointer next to
“GUIDE PROG SET”, then
press OK. The Guide Prog.
Set screen appears.
PUSH JOG
Channel position Station name
1 ARD
2 ZDF
3 WDR
AUTO CH SET
MANUAL CH SET
GUIDE PROG SET
[
5
∞
] =
[CANCEL] : EXIT
CONTINUED ON NEXT PAGE.