JVC HR-J670EK VCR User Manual


 
32
ADVANCED OPERATIONS (cont.)
MODE SET
B. E. S. T. ON
PICTURE CONTROL AUTO
AUTO TIMER OFF
O. S. D. ON
DIRECT REC ON
AUTO SP=LP TIMER OFF
POWER SAVE OFF
NEXT PAGE
[5∞] =
[MENU] : EXIT
L-2 SELECT Setting
Set "L-2 SELECT" to the appropriate mode depending on the type of unit connected to the rear
panel AV2 (L-2) IN/DECODER connector of this recorder.
1 Press MENU to access the Main Menu screen.
2 Press %fi to move the highlight bar (pointer) to "MODE SET", then press OK or
#
.
3 Press %fi to move the highlight bar (pointer) to "L-2 SELECT".
4 Press OK or
#
to select "L-2", "DECODER" or "SAT".
a–L-2 : To use this recorder as the recording deck with the player connected to the
AV2 (L-2) IN/DECODER connector, or to use the satellite receiver connected
to the AV2 (L-2) IN/DECODER connector.
b–DECODER : To use a decoder connected to the AV2 (L-2) IN/DECODER connector.
c–SAT : To view a satellite programme with the TV set while the recorder is turned
off. ( pg. 26)
5 Press MENU to return to normal screen.
If you have a satellite receiver or a decoder connected to the AV2 (L-2) IN/DECODER connec-
tor, be sure to set "L-2 SELECT" back to appropriate mode after editing.
If you're not connecting a satellite receiver or a decoder to the AV2 (L-2) IN/DECODER con-
nector, leave "L-2 SELECT" set to "L-2".
The default setting is "L-2"; if the recorder's memory backup has expired due to a power cut or
because the AC was removed from the recorder, "L-2" will be automatically selected when the
power is restored to the recorder. If you are using a satellite receiver or a decoder, be sure to
set "L-2 SELECT" back to appropriate mode.
When "L-2 SELECT" is set to "SAT", "SAT" appears on screen or display panel instead of "L-2" or
"L2".
PREVIOUS PAGE
L-2 SELECT L-2
[5∞] =
[MENU] : EXIT