Filter
Top Products
13
?
12
3
4
65
7
8
9
0
2
4
1
3
MENU
NUMBER
ACCESS SAT CONTROL
SET SCREEN
4
Press %fi to move the
highlight bar (pointer) to
“SAT CONTROL SET”,
then press OK or
#
.
ENTER SATELLITE
RECEIVER’S BRAND
5
Press the appropriate
NUMBER keys to enter the
brand code from the list in
the left column, then press
OK.
● If the brand code you
entered is invalid, the
code field is reset. Enter
the correct brand code
again.
● If the recorder is in playback or recording mode, you
cannot set the brand code.
SELECT SATELLITE
RECEIVER’S CHANNEL FOR
TESTING
6
Press the appropriate
NUMBER keys to enter
one of the channel
positions on the satellite
receiver, then press OK.
● You can select the
channel position
between 1 to 999.
● After pressing OK, the
recorder enters the Test mode.
CHECK RESULT OF TEST
7
If the satellite
receiver’s channel
number has been
changed to the same
channel as you set in
step 6...
Press %fi to move the
highlight bar (pointer) to
“CHANGED TO ...”, then
press OK or
#
to finish the
Sat Control Set mode.
If the satellite receiver’s channel number has not
been changed correctly...
Press %fi to move the highlight bar (pointer) to “NOT
CHANGED”, then press OK or
#
. Then perform the
procedure again from step 5.
SATELLITE TUNER BRAND CODE
JVC 73
AMSTRAD 60, 61, 62, 63, 92
CANAL SATELLITE 81
CANAL + 81
D-BOX 85
ECHOSTAR (VIA DIGITAL) 82
FINLUX 68
FORCE 89
GALAXIS 88
GRUNDIG 64, 65
HIRSCHMANN 64, 78
ITT NOKIA 68
JERROLD 75
KATHREIN 70, 71
LUXOR 68
MASCOM 93
MASPRO 70
NOKIA 87
PACE 65, 67, 74, 86, 92
PANASONIC 74
PHILIPS 66, 84
RFT 69
SAGEM 83
SALORA 68
SIEMENS 64
SKYMASTER 69
TPS 83
TRIAX 91
WISI 64
SAT CONTROL SET
BRAND : – –
[
0–9
] =
[MENU] : EXIT
SAT CONTROL SET
SAT PROG : – – –
[
0–9
] =
: TEST
[MENU] : EXIT
SAT CONTROL SET
SAT PROG : 111
CHANGED TO 111
NOT CHANGED
[
5
∞
] =
[MENU] : EXIT
INITIAL SET
CLOCK SET
GUIDE PROG SET
SAT CONTROL SET
[
5
∞
] =
[MENU] : EXIT
NOTES:
●
The Satellite Controller may not work with all types of
satellite receiver.
●
For some satellite receivers, you need to set its channel input
mode to 2-digit.
●
If your satellite receiver has more than two channel mode, be
sure to set to "All Channel Mode". For details, refer to the
instruction manual of the satellite receiver.
●
When selecting the satellite receiver's channel (
੬
step 6),
signals from the remote control may interfere with signals
transmitted from the Satellite Controller. In this case, move
the remote control as close to the recorder's infrared beam
receiving window as possible.