Filter
Top Products
Masterpage:Left-FullCol
50
EN
Filename [HRS7700EU3.fm]
Page 50 March 8, 2000 1:58 pm
SUBSIDIARY SETTINGS (cont.)
* The default setting is
bold
in the table below.
8
AUTO SP
]
LP TIMER
ON
OFF
When this function is set to “ON”, the recorder
automatically switches to LP mode to allow complete
recording if there is not enough tape to record the entire
programme while timer-recording in SP mode.
For Example . . .
Recording a programme of 210 minutes in length onto a
180-minute tape
Make sure you set this function to “ON”, before the timer-
recording starts.
NOTES:
●
If you have programmed the recorder to timer-record 2 or more
programmes, the second programme and those thereafter may
not fit on the tape if you set “AUTO SP
]LP TIMER” to “ON”. In
this case, make sure the mode is not engaged, then set the tape
speed manually during timer programming.
●
In order to ensure that the recording fits on the tape, this feature
may leave a slight non-recorded section at the end of the tape.
●
There may be some noise and sound disturbance at the point on
the tape where the recorder switches from SP to LP mode.
●
The Auto SP
]LP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work properly
with any tapes longer than E-180, or with some tapes of shorter
lengths.
●
If you perform timer recording with both VPS/PDC and the Auto
SP
]LP Timer activated, and the programme goes beyond its
originally scheduled length, there may be times when the
programme cannot be recorded in its entirety.
8
DIGITAL 3R
ON
OFF
When this function is set to “ON”, the Digital 3R picture
system applies edge correction to the luminance signal to
enhance detail.
NOTES:
●
Normally it is recommended to keep “DIGITAL 3R” set to
“ON”.
●
Depending on the type of tape being used, picture quality may
be better with “DIGITAL 3R” set to “OFF”.
●
If you use the recorder as the source player for editing, be sure
to set “DIGITAL 3R” to “OFF” before starting.
8
POWER SAVE
ON
OFF
When this function is set to “ON”, you can reduce the
power consumption while the recorder is turned off.
NOTES:
●
During Power Save mode ...
... the front display panel will be turned off.
... the Just Clock function (
੬
pg. 60) does not work.
... the picture may be distorted momentarily when you turn on/
off the recorder.
●
Power Save does not work when ...
... the recorder is in the Timer mode.
... the recorder’s power is turned off after timer-recording or
Instant Timer Recording.
... the Automatic Satellite Programme Recording mode is
engaged (
੬
pg. 34).
... “L-2 SELECT” is set to “DECODER” or “SAT” (
੬
pg. 37).
Total 210 minutes
Approximately 150 minutes Approximately 60 minutes
SP mode LP mode
HRS7700EU3.fm Page 50 Wednesday, March 8, 2000 1:58 PM