Filter
Top Products
initial settings14
before you start
The power cord must be
plugged in and
connected to the VCR
The VCR must be turned
on
The Remote Control
must have batteries
inserted
The TV set must be
turned on
Video Channel Set
The VCR can send picture signals to the TV set in one of two ways; RF
(ordinary cable included with this VCR) and AV (via a 21-pin SCART cable
available from TV and Hi-Fi dealers). Depending upon which method you
use, the VCR must have the correct method set up in order to work. The
Video Channel is originally set to channel 52 but if for any reason this fails to
happen, the instructions below describe how to set the Video Channel
manually.
Set channel on TV
Select the vacant position 52 on you TV.
Access Video Channel Set Mode
Press o button on the Remote Control to enter the standby mode. Press and
hold PR+ or – on the VCR for more than 3 seconds.
HR-V205EK-EN/p13-16 6/19/03, 1:35 PM14