Filter
Top Products
40 EN
TIMER RECORDING (cont.)
You can directly program the VCR’s timer to record up to 8
shows, as far as a year in advance. Remember, the clock must be
set before you can program the timer (੬ pg. 7 or 9).
On-Screen
Timer
Programming
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover
the hole with adhesive tape, then load.
● The VCR comes on, and the counter is reset,
automatically.
ACCESS ON-SCREEN
MENU
2
Press MENU as many times as necessary to bring up the
Main Menu screen.
ACCESS PROGRAM SET
SCREEN
3
Make sure the highlight bar (arrow) is on "PROGRAM
SET", then press OK.
SELECT PROGRAM NUMBER
4
Press the appropriate
NUMBER keys or CH5
∞
or
SHUTTLE PLUS %
fi
to
select a vacant program
number, then press OK. The
first time you set the timer
programming function, all
the program numbers will
be blank; in this case just
press OK when the Program Set screen appears.
SET PROGRAM
INFORMATION
5
Press the appropriate NUMBER keys to set the date,
start/stop time and channel number. Press CH5
∞
or
SHUTTLE PLUS %
fi
to set AM/PM and tape speed (SP
or EP). Press OK after AM/PM, channel number and
tape speed settings.
* If you are using a DBS receiver, see "ATTENTION FOR
DBS RECEIVER USERS" on next page.
● Any information comprised of 1 digit (except the
channel number) should have a "0" entered before it.
● It is possible to set all information using the CH
5
∞ or
SHUTTLE PLUS
%
fi
button.
(In this case, press OK after each setting.) Do not use
the CH ∞ or SHUTTLE PLUS fi button to set the date.
● At the Program Set screen, the setting that can be set
blinks. When setting of a highlighted item is completed,
the highlight bar moves down by 1 line to the next item.
** You can record selected programs at the same time
every weekday, or once a week. Before entering the
month, press NUMBER key “8” (DAILY) or “9”
(WEEKLY). Either "DAILY" or "WEEKLY" appears.
Press again and "DAILY" or "WEEKLY" disappears.
For weekly recording, the desired date for the day of
the week must be entered.
Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
2
2
q
5
/
8
6
PROGRAM 1
DATE – –/– –
START – –:– – AM
STOP – –:– – AM
CHANNEL – – SP
PRESS NUMBER KEY (O–9)
OR (5,∞), THEN (OK)
PRESS (MENU) TO END
EXAMPLE
If you program the VCR to timer
record a show on December 24
on channel 40 from 12:00 noon
to 1:00 PM in SP mode, the
screen will look like this:
PROGRAM 1
DATE 12/24 WED
START 12:00 PM
STOP 1:00 PM
CHANNEL 40 SP
PRESS NUMBER KEY (O–9)
OR (5,∞), THEN (OK)
PRESS (MENU) TO END
3
¶
4¢
78
1
¡
1
2
3
456
7
8
0
9
NUMBER
OK
CH
MENU
NUMBER "8"
NUMBER "9"
CH
SHUTTLE PLUS
MENU
OK