Filter
Top Products
Filename [XV48EX_EN_07S-VHS.fm]
Masterpage:Left+
24 EN
Page 24 October 9, 2004 10:34 pm
OPERATIONS ON VHS DECK (cont.)
SHOWVIEW
TM
Timer
Programming
With the SHOWVIEW system, timer programming is greatly
simplified because each TV programme has a corresponding
code number which your unit is able to recognize.
A
Select the VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
B
Access the SHOWVIEW screen.
C
Enter the SHOWVIEW number.
D
Access the SHOWVIEW Program screen.
● If the number you entered is invalid, “ERROR” appears on the
TV screen. Press & and input a valid S
HOWVIEW number.
E
Set the tape speed.
Press p.
F
Set the VPS/PDC mode.
Press VPS/PDC (number key “7”) to select “ON” or
“OFF.”
● If “VPS/PDC ON” is displayed on the TV screen, “VPS/PDC” is
set to “ON.”
● If “VPS/PDC OFF” is displayed on the TV screen, “VPS/PDC”
is set to “OFF.”
੬ “VPS/PDC Recording” on page 25.
Before performing the SHOWVIEW Timer
Programming:
● Make sure that the unit’s built-in clock is set properly.
● Insert a cassette with the safety tab in place. The unit will
come on automatically.
● Turn on the TV and select the video channel (or AV mode).
● Slide the TV/VCR/DVD switch on the remote control to the
right.
Press PROG.
Slide to the
right.
SHOWVIEW SYSTEM
Press the number keys to
enter the S
HOWVIEW number
of a programme you wish to
record.
● If you make a mistake, press &
and input the correct number.
Press ENTER, then the
S
HOWVIEW Program screen
appears (if you’re just starting
out, “P1” appears).
IMPORTANT
Make sure the channel position number you wish to record is
displayed; if not, or “TV PROG” shows “– –,” press PR +/– to
input the channel position number on which your unit
receives the station, then press ENTER or e.
SHOWVIEW SYSTEM
XV48EX_EN_01.book Page 24 Saturday, October 9, 2004 10:34 PM