Filter
Top Products
13
Control four JVC VCRs
2
Press and hold VCR on the remote control until you finish the
step 2.
1
The remote control is capable of
controlling four JVC VCRs
independently; one set to respond
to your remote control’s A code
control signals and the other set to
respond to B, C, D code control
signals. The remote control is
preset to send A code signals
because your DVD/VCR is initially
set to respond to A code signals.
You can easily modify your DVD/
VCR to respond to the other code
signals.
Make sure TV/VCR/DVD switch has been slided to VCR/DVD.
Preparation:
Press one of the following buttons to enter the desired code,
then press ENTER.
1: sets the remote control code to “A”
2: sets the remote control code to “b”
3: sets the remote control code to “C”
4: sets the remote control code to “d”
3
To turn off the unit, press POWER on the front panel.
4
Press PLAY on the front panel for 5 seconds. The current
setting code of the unit appears on the display.
5
Press STOP on the remote control. The new code is transmit-
ted to the unit and blinks for about 4 seconds on the display,
then the clock time appears.
6
Press POWER on the remote control. When the unit is turned
on, the setting is complete. If the unit is NOT turned on, repeat
from step 1.
PLAY
POWER