Filter
Top Products
Filename [XVC27U_10Subsidiary.fm]
Masterpage:Left+
78 EN
Page 78 27 January 2004 11:22 am
SUBSIDIARY SETTINGS (cont.)
Picture Settings
* The default setting is bold in the table below.
Audio Settings
* The default setting is bold in the table below.
8 MONITOR TYPE
16:9
4:3 LB
4:3 PS
You can select the monitor type depending the TV used when you play back
DVD VIDEO discs recorded for wide-screen TVs. For more details, refer to
“Monitor Set (DVD deck)” (
੬ pg. 18)
8 PICTURE SOURCE
AUTO
FILM
VIDEO
You can obtain optimal picture quality by selecting whether the content on the
disc is processed by field (video source) or by frame (film source).
Normally set to “AUTO”.
AUTO: Used to play back a disc containing both video and film
source materials. This unit recognizes the picture type (film or
video source) of the current disc according to the disc
information.
FILM: Suitable for playing back a film or progressive source disc.
VIDEO: Suitable for playing back a video source disc with relatively a
few moments.
● If the playback picture is unclear or noisy, or the oblique lines of the picture
are rough, try to change to other modes.
8 SCREEN SAVER
ON
OFF
The TV screen may be burned out if a static picture is displayed for a long time.
When this function is set to “ON”, the unit automatically activates the screen
saver function if a static picture, such as an on-screen display or menu is
displayed for over 5 minutes.
8 FILE TYPE
AUDIO
STILL PICTURE
You can select files to play back, when both MP3 files and JPEG files are
recorded on a disc.
AUDIO: Select this to play back MP3 files.
STILL PICTURE: Select this to play back JPEG files.
NOTE:
Be sure to open and close the disc tray after changing the setting. The unit reads the disc
again and the selected file type can be recognized.
8 DIGITAL AUDIO OUTPUT
PCM ONLY
DOLBY DIGITAL/PCM
STREAM/PCM
Set to the appropriate mode according to the type of the device connected to
DIGITAL AUDIO OUT connector on the rear of unit.
It is not necessary to set this mode when you connect no device to DIGITAL
AUDIO OUT connector.
PCM ONLY:
Select this when you connect the unit’s DIGITAL AUDIO OUT
connector to the linear PCM digital input connector of other audio
device.
DOLBY DIGITAL/PCM:
Select this when you connect the unit’s DIGITAL AUDIO OUT
connector to the digital input connector of a Dolby Digital decoder
or an amplifier with a built-in Dolby Digital decoder.
STREAM/PCM:
Select this when you connect the unit’s DIGITAL AUDIO OUT
connector to the digital input connector of an amplifier with a built-
in DTS, Dolby Digital, or MPEG multichannel decoder.
XVC27U_10Subsidiary.fm Page 78 Tuesday, January 27, 2004 11:22 AM