JVC AV 27F485 CRT Television User Manual


 
Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
preset with a lock code of “0000”. You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
Press the MENU button
π
To SET LOCK CODE
è
To operate (lock icon appears)
Press ZERO to access the lock code
The first digit will be highlighted
è
To select the number
π
To move to the next digit
Continue to follow these directions for all four numbers
π
To FINISH
è
To save settings and exit
(your lock code is now set)
Press the EXIT button when finished
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
Notes:
When a viewer attempts to watch a blocked channel, this message appears:
The channel will remain blocked until the correct lock code is entered (see above for information
on setting your lock code).
Initial Setup
31
Set Lock Code
 
  

 
 
 

  
  
  
    
     
    
27\32\36F475\485 English 1/27/04, 11:23 AM31