Filter
Top Products
10 key direct access
To move directly to a specific channel, press that channel's numbers on the remote's 10 key pad. For single-digit
channel numbers, press "0" then the channel number. For channels above 100, press the 100+ button, then the
remaining two digits on the 10 key pad.
CHANNEL -/+ BUTTON
To scan through the channels, press either the CH A N N E L + or CH A N N E L - button. You will move through the
channels in numerical ord e r.
• After you operate the Auto Tuner Setup (page 15), all of the empty channels will be removed from scanning.
When you scan you will only receive clear, active channels.
H y p e rs c a n
With JVC's Hyperscan feature you can zip through the channels at a rate of five per second. To use Hyperscan,
p r ess and hold either the CH A N N E L+ or CH A N N E L - buttons. After the first few channels scan at normal speed, the
rest will move by at five per second. To scan at normal speed, press and release the CH A N N E L+ / - b u t t o n .
Regular Return
P r ess and release the RE T U R N+ button to re t u rn to the previous channel viewed. For example, select a channel,
then select another channel using the 10 key pad buttons. You can now flip back and forth between these two
channels by pressing RE T U R N+.
RETURN+
With RE T U R N+ You can program your TV to always re t u rn to a specific channel. Press and hold down the RE T U R N+
button for three seconds. The message, "R E T U R N CHANNEL PROGRAMMED!" will appear on-screen. Now
when you scan through the channels, pressing RE T U R N + will bring you back to your programmed channel.
To cancel the RE T U R N+ channel, press and hold the RE T U R N+ button for three seconds. The message "RETURN
CHANNEL CANCELLED!" will appear on-scre e n .
• Pressing any number key or turning off the TV will also cancel the RE T U R N+ c h a n n e l .
• Press the PO W E R button on the remote control or the front panel of the TV. The ON TIMER lamp will glow red.
• Make sure the TV/CAT V switch on the remote is set to TV (RM-C381 and RM-C382 only). Move the switch to
C AT V only if you plan to operate a cable box. On the CATV setting the remote will only operate the cable box
f u n c t i o n s .
• To turn the power off, press the Power button again. The ON TIMER lamp will go out.
• The ON TIMER lamp will glow red when the On/Off Timer is set (page 24), even when the TV power is off.
Getting Started 11
1
2
3
4
POWER
To control the volume level, use the VO L U M E+/- b u t t o n s on the remote control or on the TV's front panel. Use
the VO L U M E - button to lower the volume. Press the VOLUME+ button to raise the volume.
Press the MUTING button to instantly turn the volume to zero. Press MUTING again to return to the previous
volume level.
ADJUSTING VOLUME
CHANGING CHANNELS
VOLUME 13
|||||||
-------------------