Filter
Top Products
These quick setup pages will provide you, in three easy steps, with the basic information you
need to begin using your new television right away.
If you have questions, or for more detailed information on any of these steps, please consult
other sections of this manual.
Before you can operate your remote control, you first need to install the batteries (included).
For Remote Control RM-C1255G,
RM-C1254G and RM-C1253G: Lift and pull
the latch on the back of the remote control
to open. Insert two batteries (included)
carefully noting the “+” and “–” markings,
placing the “–” end in the unit first. Snap the
cover back into place.
When you change the batteries, try to
complete the task within three minutes.
If you take longer than three minutes,
the remote control codes for your VCR,
DVD, and/or cable box/satellite receiver
may have to be reset. See pages 20 - 23.
For Remote Control RM-C203: With your
thumb, push the latch on the back of the
remote control inward, and while holding it
there, pull the battery cover out with your
index finger. Insert the battery (included)
carefully noting the “+” and “–” markings.
Push the cover back into place.
Getting Started
Step 1 – The Remote Control
12
Key Feature Buttons
The four key feature buttons at the center of the
remote can be used for basic operation of the
television. The top and bottom buttons will scan
forward and back through the available channels.
To move rapidly through the channels using JVC’s
Hyperscan feature, press and hold CH+ or CH–.
The channels will zip by at a rate of five channels per
second. The right and left buttons will turn the volume
up or down. These buttons are also marked with
four arrows and are used with JVC’s onscreen menu
system. To use the onscreen menus, press the MENU
button.
Note: Illustration of remote
control RM-C1253G
Quick Setup Getting Started
FE2,GE2 English OK 2/18/03, 1:40 PM12