Filter
Top Products
42
Tuner Setup
Auto Tuner Setup
The auto tuner setup function is described on page 23 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M
ENU button
π†
To "Tuner Setup"
è
To enter
π†
To "Auto Tuner Setup"
è
To enter
è
To choose "Cable" or "Air"
π†
To "Scan Mode"
è
To choose "Auto", "STD", "HRC" or "IRC"
†
To "Start"
Press the OK button (Programming will take serveral minutes)
The auto tuner is finished when the message "Programming Over !" appears onscreen.
Press the MENU button when finished
Exit
MENU
Select Operate
Start
Tuner Mode
Scan Mode
Tuner Setup > Auto Tuner Setup
Cable
Auto
Back
BACK
–
+
Channel Summary
Channel summary allows you to customize the line-up of channels received by your TV.
Regarding analog channels, you can add or delete channels from the line-up or prevent any
unauthorized viewers from watching any or all 191 channels. Regarding digital channels, the
only channels that will appear are the ones that are broadcasting.
Press the M
ENU button
π†
To "Tuner Setup"
è
To enter
π†
To "Channel Summary"
è
To operate
The Channel summary screen will now be displayed with
the channels set to scan marked with an “√”. Regarding
analog channels, you can delete channels from the scan
by removing the “√”. If any channels were missed during
auto tuner setup and you wish to add them, you may by
placing an “√” next to the channel number.
• Digital channels can not be added to the channel summary if the auto tuner setup did not
find them.
π†
è
To the "Scan" column
Press the OK button to include or delete from scan
Press the MENU button when finished
Exit
MENU
Select Operate
Tuner Setup > Channel Summary
Back
BACK
–
+
OK
001
002
003
004
005
006
FOX
ABC
CNN
NBC
BOX
NHK
Ch No. Scan Station
Note:
• The number of a digital channel may change, depending on the time of some broadcastings.
If this channel existed and now had disappeared, the lock channel or scanned channel by the
channel summary for that channel will be cancelled.
Notes:
• When the Tuner Mode is set to "Cable", it is possible to select "Scan Mode"
• If no channels were found using Auto Tuner Setup, check your antenna cable and the
settings for Tuner Mode/Scan Mode.
LCT2121-001A-A English.indd 42LCT2121-001A-A English.indd 42 6/21/06 9:30:37 AM6/21/06 9:30:37 AM