Filter
Top Products
27
ENGLISH
2
Press 5/∞ to move the cursor (3) to
“STATUS DISPLAY.”
• The Setup Menu consists of two pages. If you keep
pressing 5/∞, you can move to the other page from
the current page.
3
Press 2/3 to select the desired setting.
Each time you press the button, the Status Display
function alternates between “ON” and “OFF.”
To cancel the Status Display function, select “OFF.”
4
Press MENU/EXIT (or MENU on the
Monitor) once to exit from the menu
operations.
Mounting the Monitor Vertically
When mounting the Monitor vertically, the temperature inside
the Monitor rises more than it is mounted horizontally. To
provide better heat dissipation, it is necessary to perform the
adjustment to switch fan speeds.
1
On the remote control:
Press MENU/EXIT while holding
VOLUME – to display the Setup Menu.
On the Monitor:
Press MENU while holding 2 to display
the Setup Menu.
2
Press 5/∞ to move the cursor (3) to
“VENTILATION MODE.”
• The Setup Menu consists of two pages. If you keep
pressing 5/∞, you can move to the other page from
the current page.
3
Press 2/3 to select “V.”
Each time you press the button, the Ventilation Mode
alternates between “H (horizontal mounting)” and “V
(vertical mounting).”
4
Press MENU/EXIT (or MENU on the
Monitor) once to exit from the menu
operations.
Cursor (3)
AUTO SLEEP
CONTROL LOCK
STATUS DISPLAY
VENTILATION MODE
HD SIGNAL MODE
WHITE BALANCE
SET-UP MENU 1/2
ADJUST:
SELECT:
EXIT:
MENU
: 1MIN.
: ON
: ON
: H
: 1080i
Setting the High-Definition Signal Types
You can select one of the High-Definition (HD) signal types
through the COMPONENT terminals — 1080i or 1035i.
Normally set it to “1080i.”
1
On the remote control:
Press MENU/EXIT while holding
VOLUME – to display the Setup Menu.
On the Monitor:
Press MENU while holding 2 to display
the Setup Menu.
2
Press 5/∞ to move the cursor (3) to
“HD SIGNAL MODE.”
• The Setup Menu consists of two pages. If you keep
pressing 5/∞, you can move to the other page from
the current page.
3
Press 2/3 to select the desired setting.
Each time you press the button, the HD signal type
alternates between “1080i” and “1035i.”
• You can select either “1080i” and “1035i” according to
the HD signal you input — whichever gives you
proportionally shaped pictures.
4
Press MENU/EXIT (or MENU on the
Monitor) once to exit from the menu
operations
Using the Pixel Shift Function
This function periodically shift the position (pixels) of the
displayed picture on the screen so that you can avoid the
screen from being burned in.
1
On the remote control:
Press MENU/EXIT while holding
VOLUME – to display the Setup Menu.
On the Monitor:
Press MENU while holding 2 to display
the Setup Menu.
Cursor (3)
AUTO SLEEP
CONTROL LOCK
STATUS DISPLAY
VENTILATION MODE
HD SIGNAL MODE
WHITE BALANCE
SET-UP MENU 1/2
ADJUST:
SELECT:
EXIT:
MENU
: 1MIN.
: ON
: ON
: H
: 1080i
Cursor (3)
AUTO SLEEP
CONTROL LOCK
STATUS DISPLAY
VENTILATION MODE
HD SIGNAL MODE
WHITE BALANCE
SET-UP MENU 1/2
ADJUST:
SELECT:
EXIT:
MENU
: 1MIN.
: ON
: ON
: H
: 1080i
(To be continued on the next page)
24-30.GD-V4210PZW[EN]/f 00.9.29, 5:55 PM27