Filter
Top Products
EN
33
* The default setting is bold in the table below.
When this function is set to “ON”, this VCR checks the condition of the
tape in use during playback, and compensates to provide the highest-
possible playback pictures.
This function helps you to adjust the playback picture quality according
to your preference.
NOTES:
●
When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not
change until you select again.
●
Select "EDIT" when you are dubbing tapes (
੬
pg. 35). After you finish dubbing
the tapes, select “AUTO” (“NORM” when “AUTO PICTURE” is “OFF”.)
● When this function is set to “ON”:
The timer recording standby mode is automatically engaged when the
VCR is turned off. It is temporarily canceled when the VCR is turned
on. You do not have to press TIMER to engage or disengage the timer
recording standby mode.
● When this function is set to “OFF”:
For safety, all buttons except TIMER are disabled while the VCR is in
the timer recording standby mode. To use the VCR as usual, press
TIMER.
When this function is set to “ON”, various VCR status information (on-
screen display) appears on the screen.
NOTES:
●
When you use this VCR as the playback VCR for editing a tape, be sure to set
this function to “OFF”; otherwise, the VCR status information (on-screen
display) will be recorded on the edited tape.
●
If you select a channel on which no signal is received, the channel number is
displayed regardless of this function setting.
Ⅵ PICTURE CONTROL
AUTO (NORM):
Normally select
this. Picture quality is
adjusted automatically.
When “AUTO PICTURE” is
“OFF”, “NORM” will appear
instead of “AUTO”.
EDIT: Minimizes picture
degradation during editing
(recording and playback).
SOFT: Reduces image
coarseness when viewing
overplayed tapes
containing much noise.
SHARP: Clearer, sharper-edged
picture when viewing
images with much flat,
same-colored surfaces
such as cartoons.
Ⅵ AUTO PICTURE
ON
OFF
Ⅵ AUTO TIMER
ON
OFF
Ⅵ SUPERIMPOSE
ON
OFF