Filter
Top Products
4
Features
5 4-heads stereo Hi-Fi video cassette player
5 Mountable in either vertical or horizontal posture
thanks to the highly reliable vibration-resistant
design
Protection circuits
(self-diagnosing circuits)
This video cassette player incorporates some protec-
tion circuits inside.
If this video cassette player is used as it is dewed, it
may damage the tape and video heads.
Dew sensor circuit
5 When the cabin whose temperature is consider-
ably low is rapidly heated or the humidity in the
cabin is considerably high, insides of the wind-
screen and cabin windows are sometimes fogged.
At the same time, inside of the video cassette player
mounted on the car is dewed.
5 In such the case (dewed condition), the dew sensor
circuit functions to stop machine operation with
indication of blinking indicator lamp in green,
and "DEW PLEASE WAIT" appears on the screen.
When the machine falls into such the status, wait
for several hours until the indicator lamp stops
blinking and lights continuously.
High temperature sensor circuit
5 When the temperature of the machine becomes con-
siderably high, the high temperature sensor circuit
functions to stop machine operation with indication
of blinking
indicator lamp in red, and "HIGH
TEMP PLEASE WAIT" appears on the screen. When
the machine falls into such the status, turn off the
machine and wait for a while until the indicator
lamp stops blinking while leaving it in a cool place
to lower the temperature. When turning on the ma-
chine again, make sure that the indicator lamp
does not blink before starting operation.
Abnormal voltage sensor circuit
5 When the source loop circuit of the machine
detects voltage out of the operation range, the
abnormal voltage sensor circuit functions to
turn off the machine with indication of blink-
ing the
indicator lamp in orange, and
"VOLTAGE PLEASE CHECK" appears on the
screen.
In such a case, make sure that the machine is
connected properly or battery voltage is sufficient.
Note: This video cassette player should be used
with DC12V only.
Tape protection circuit
5 When the machine remains in the still playback or
slow playback mode for 5 minutes or longer, the tape
protection circuit functions to stop mode the ma-
chine for protecting the tape.
ACCESSORIES
• Check to see if the following accessories are supplied with the video cassette player.
Mounting bracket x 2
Tapping screw (φ 5 x 20 mm) x 4
Screw (M5 x 8 mm) x 4
Velcro tape x 2 sets
AV cord
(5 m/16.7ft. long)
Power cord
(5.5m/18.2ft. long)
Remote sensor unit
Remote controller Round battery
(CR2025)
Remote control data cord
(5m/16.7ft. long)
KV-V8E(EN) 01.1.26, 11:17 PM4