Filter
Top Products
25
ENGLISH
Getting Started Preparation Basic Operation Settings Troubleshooting Others
Item values shown in are factory settings.
zItems that can be configured differ according to the input signals.
z“Contrast”, “Brightness”, “Color” and “Sharpness” can also be configured from the remote control. (pP12)
z“Tint” can only be adjusted when NTSC signals are input to the video or S-video input terminal.
* The red, green and blue colours can be adjusted and registered respectively.
zThis setting can also be configured from the remote control. (pP12)
Setting Menu
Image > Image Adjust
A Contrast
Adjusts the contrast of the projected image.
(Black) b50 to 50 (White)
B Brightness
Adjusts the brightness of the projected image.
(Darken) b30 to 30 (Brighten)
C Color
Adjusts the colour density of the projected image.
(Lighten) b50 to 50 (Darken)
D Tint
Adjusts the hue of the projected image.
(Red) b30 to 30 (Green)
E Sharpness
Adjusts the outline of the projected image.
(Soft) b30 to 30 (Sharp)
F DNR
Adjusts the strength of noise removal of the projected image.
(Weak) 0 to 30 (Strong)
Image > Color Temp.
G Color Temp.
Sets the colour temperature of the projected image.
Low Select this to give a reddish tinge to the image.
Middle Select this to have a balanced image.
High Select this to give a bluish tinge to the image.
Memory10
Red (Less red) b255 to 0 (More red)
Green (Less green) b255 to 0 (More green)
Blue (Less blue) b255 to 0 (More blue)
Memory20
Red (Less red) b255 to 0 (More red)
Green (Less green) b255 to 0 (More green)
Blue (Less blue) b255 to 0 (More blue)
DLA-RS2E_EN.book Page 25 Monday, February 25, 2008 5:18 PM