Filter
Top Products
35
Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes pre-
set with a lock code of “0000”. You may change the code to any four-digit number you wish. To
change the lock code, follow the steps below.
Press the M
ENU button
π†
To "Initial Setup"
è
To enter
π†
To "Set Lock Code"
è
To operate (Password input screen will appear)
Enter the password by using the 10 button
keypad
The Set Lock Code screen will appear
To set the password, use the 10 button keypad
Press the OK button to finish (your lock code is now set)
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
Notes:
When a viewer attempts to watch a blocked channel,
this message appears:
The channel will remain blocked until the correct lock
code is entered (see above for information on setting
your lock code).
Initial Setup
Set Lock Code
This programming exceeds
your rating limits.
Please enter lock code
by 10 key pad to unlock it.
No. - - - -
When a viewer attempts to watch a guarded channel, the following message appears:
To watch a channel that you have locked, enter the
Lock Code using the 10 key pad.
If the wrong code is entered, the message "Invalid Lock
Code !” will appear on the screen.
The channel cannot be accessed until the correct code
is entered.
Notes:
• Once a channel has been unlocked, it will remain unlocked until the television is turned off.
• See also “Set Lock Code”.
Channel Guard Message
This channel is locked
by channel guard.
Please enter lock code
by 10 key pad to unlock it.
No. - - - -
Lock Code 0 1 2 3
Set Clear
Initial Setup > Set Lock Code
Select
BACK
Back
MENU
ExitOperate
OK
LCT2224-001B-A English.indd 35LCT2224-001B-A English.indd 35 2/15/07 11:05:04 AM2/15/07 11:05:04 AM