Filter
Top Products
E20
Mail Slot
1.
In the normal display mode, press the MODE key.
(The menu display appears.)
2.
Press the SELECT key 7 times.
("8. IMPORT/EXPORT" appears.)
3.
Press the ENTER key.
(Select "8. IMPORT/EXPORT".)
4.
Press and hold the SELECT key for more than 5 sec-
onds.
(Wait until the display starts to blink.)
5.
Release the SELECT key when the input start tray
message is prompted.
6.
Enter the start tray number(001-200*
1
) using the 10-
key pad.
•If the number is wrong, input a new 3-digit tray No.(ex.
001) again.
7.
Press the ENTER key.
8.
Enter the end tray number(001-200*
1
) using the 10-key pad.
•If you wish to use the import/export operation for a
single disc, either enter the same end tray number as
the start tray number or press the ENTER key without
entering any number.
9.
Press the ENTER key.
•You can cancel the following operations by pressing
and holding the ENTER key for 5 seconds during the
import/export operation. If the mail slot opens after
cancelling the operation, press the LOAD/EJECT
key.(The tray in operation will be returned to the maga-
zine; then the import/export operation will be com-
pleted.)
*
1
MC-8200LU. (001 - 600 for the MC-8600LU)
6-2. Import/export operation
When loading/ejecting discs from any chosen tray by the mail slot without the control of the host computer, follow the proce-
dure shown below.
• During the import/export operation, the host computer commands which include the carrier operations cannnot be ex-
ecuted.
1 . NORMA L D I SP L AY
2.ERROR DISPLAY
8
.IMPORT/EXPORT
9.DRIVE D I S P L A Y
P
USH SEL . KEY FOR
IMPORT /EXPORT
I
NPUT START
TRAY No . : –––
I
NPUT START
TRAY N
1
o. : 15
I
NPUT END
TRAY No . : –––
I
NPUT END
TRAY N 1o. : 24
IMP ORT / EXPORT
TRAY No . : 115
P
USH SEL . KEY FOR
IMPORT /EXPORT