Filter
Top Products
38
VCR Plus+
Timer
Programming
TIMER RECORDING
Before VCR Plus+ Timer programming, see "VCR Plus+
Setup" on page 19.
During VCR Plus+ and on-screen timer programming, the
Illumi-Guide feature tells you which button on the remote
control must be pressed next by lighting it up. To use this
feature, with the TV/CABLE/VCR switch set to "VCR", press
ILLUMI GUIDE before performing step 2. (MENU, REW, PLAY,
FF light up at this time.)
If you aren't going to use the Illumi-Guide feature, go directly to
step 1.
6
q
When Using The Illumi-Guide Feature
● Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press MENU as many times as necessary to return to the
normal screen and extinguish all illuminated buttons,
and re-perform the timer programming procedure from the
beginning.
● If for some reason the remote control's signal is not received
by the VCR, press MENU as many times as necessary to
return to the normal screen and extinguish all
illuminated buttons, and re-perform the timer programming
procedure from the beginning.
OK
12
45
3
6
8
0
7
9
MENU
OK
NUMBER
CANCEL
ILLUMI GUIDE
TV/CABLE/VCR
TV/VIDEO
LOAD A CASSETTE
1
Make sure the record safety tab is present.
● The VCR’s power comes on automatically.
● If you’re watching on channel 3 or 4, press TV/VIDEO
to select the VIDEO mode. VIDEO is displayed on the
front display panel.
ACCESS VCR PLUS+ SCREEN
2
Press MENU on the remote
control.
● The clock must be set in
order to access the VCR
Plus+ screen. If you
haven’t set the clock, the
Main Menu screen
appears when you press
MENU. Refer to page 7 for the Dual Quick Set
procedure or page 9 for the clock setting procedure.
● If you are using the Illumi-Guide feature, the following
buttons will light up: NUMBER keys (0 – 9), CANCEL
and MENU.
ENTER PLUSCODE NUMBER
3
Press the appropriate NUMBER keys to enter the
PlusCode number printed in the TV listings for the TV
program you wish to record.
● To make corrections, press CANCEL and input the
correct PlusCode number.
● If the PlusCode number you input is incorrect,
"ERROR" may appear on the screen to advise you of
the error. This happens when the PlusCode number is
for a program which has already passed. "ERROR" is
displayed for about 4 seconds and the VCR Plus+
screen reappears (step 2).
● If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys
(0 – 9), CANCEL and MENU.
VCR PLUS+
PRESS NUMBER KEY(0-9)
PRESS (MENU) TO MAIN MENU