Filter
Top Products
Masterpage:Right+
EN 47
Filename [SR-MV45_55U_10Editing.fm]
Page 47 January 10, 2007 1:18 pm
EDITING
Dubbing A Part Of A Cassette
You can dub the selected scenes on a tape to the DVD disc,
starting and stopping wherever you wish.
NOTES:
● There may be a discrepancy of several seconds between where you
intend dubbing to start, and where it actually starts.
● The superimposed indication during the operation or dubbing is not
recorded.
● It is not possible to dub a tape with a copy protection signal.
● If the recording capacity of disc become full, the tape stops
automatically.
● It is not possible to perform other operations like Live Memory
Playback. Check the recorded program on the disc after dubbing.
● When dubbing can not be performed properly, set “BLUE BACK” to
“OFF”. (੬ pg. 61)
1 Press VCR/DVD repeatedly so that the VCR lamp lights up on
the unit.
2 Press SET UP to access the Main Menu screen.
3 Press rt to select “COPY SET”,
then press ENTER.
4 Press rt to select “COPY MODE”,
then press ENTER to select “FULL
COPY” or “1 PROG.”.
● Pressing ENTER toggles the setting
between “FULL COPY” and “1 PROG.”.
5 Press SET UP to complete the
setting.
● When “1 PROG.” is selected, recording
will stop when an index code or unrecorded portion is detected.
6 Load a cassette you want to dub on the VCR deck, and a
recordable disc on the DVD deck.
7 Press VCR]DVD to select the dubbing direction. The dubbing
(DUBB.) lamp lights up on the unit.
8 Locate the point from where you want to start dubbing, then
pause playback by pressing the following buttons: 4, 5, 3,
8, 9
9 Prepare the DVD deck for dubbing.
A Press VCR/DVD repeatedly so that the DVD lamp lights up on
the unit.
B Press REC MODE repeatedly to set the recording mode.
(੬ pg. 36)
C Press 7 and 9 simultaneously so that the DVD deck enters the
Record Pause mode.
10 Press and hold DUBB. for more than 2 seconds to start
dubbing. The dubbing (DUBB.) lamp blinks on the unit.
● When dubbing a tape-end recorded VHS tape, set the input of this
unit to a no signal input before dubbing.
● To stop dubbing, press 8.
● Upon completing dubbing, dubbing ends automatically even without
pressing 8. Press VCR]DVD to turn off the dubbing (DUBB.)
lamp.
Manual Dubbing (From VCR To DVD)
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/DBS/DVD switch to DVD.
1
4
7
2
5
8
0
3
6
9
REC MODE
7
5
3
4
98
VCR/DVD
8
VCR ]
DVD
DUBB.
7
3
VCR/DVD
REC
MODE
U
5
9
DUBB. Lamp
PRESS ( , ), THEN (OK)
(SET UP) TO END
COPY SET
FUNCTION SET
MAIN MENU
( , ) THEN (ENTER)
(SET UP) TO END
COPY MODE FULL COPY
FULL DISC OFF
AUTO FINALIZE OFF
COPY SET
SR-MV45_55US.book Page 47 Wednesday, January 10, 2007 1:18 PM