Filter
Top Products
9
Setup the wireless system
Note:
If there is a product with a strong electromagnetic field
nearby, interference may occur.
(Ex : Micro wave oven)
LED indicator of
Wireless Receiver
* LED indicator - “BLUE”
The
Wireless Receiver is receiving the signal of the
Wireless transmitter which is incorporated in the main
unit
.
* LED indicator - “RED”
The Wireless Receiver is in standby mode.
Initial Setting an ID of Wireless
1 Connect the Wireless Receiver and the rear
speaker (right, left) with the speaker
cables.
2 Connect the power cord of the Wireless
Receiver to the outlet.
3Turn on the main unit and Wireless Receiver.
The wireless transmitter in the main unit and
wireless receiver will be automatically connected.
“MATE OK” appears in display window.
Setting an ID of Wireless
When the unit is manufactured, the ID is already set.
If an interference occurs or you use a new Wireless
Receiver, an ID should be set again.
1. Turn on the main unit and Wireless Receiver.
2. Press and hold STOP(x) on the front of unit and
MUTING on the remote control.
“REMATE” appears in display window.
3. Turn off the Wireless Receiver
.
4. Turn on the Wireless Receiver:
A new ID is set..
Notes:
If there is a strong electromagnetic wave product nearby,
interference may occur. Put the unit (Wireless Receiver
and main unit) away from there. (Ex: Microwave oven)
If there is no audio signal for longer than 10 minutes, the
Wireless Receiver will automatically switch to standby
mode. In power saving mode, both LEDs will turn red.
LEDs will turn blue when there is any audio signal back.
If you operate main unit then wireless speakers (rear
speakers) sound within a few seconds in standby mode.
Set the distance between this unit and Wireless Receiver
within 10m.
Optimum performance can be implemented only when the
Wireless Transmitter and the Wireless Receiver within
distance of 2m to 10m is used since communication
failure may occur if longer distance is used.
It takes a few seconds (and may take longer) for the
Wireless Transmitter
and
Wireless Receiver
to
communicate with each other.
Installation and Setup