JVC HR-A437E VCR User Manual


 
7
Clock Set
The following procedures are for the A230E, A233E, A430E
and A433E.
TURN THE RECORDER ON
1
Press OPERATE.
ACCESS CLOCK SET
DISPLAY
2
Press CLOCK on the remote control. The Clock Set
display appears.
SET DATE AND TIME
3
Press PUSH JOG %fi to set the hour, then press OK.
The “minutes” display begins blinking. Repeat the
procedure to set the minutes, day, month and year.
START CLOCK OPERATION
4
Press CLOCK.
NOTES:
During clock setting, if the day and month data are invalid
(such as 31st April), the month digits are cleared automati-
cally and the day digits begin blinking. Input the correct data.
If, in step 3, the year digits are automatically cleared and the
day digits begin blinking, it is possible that you have input
29th February for a non-leap year. Input the correct data.
The following procedures are for the A237E and the A437E.
If you performed Auto Channel Set ( pg. 6), the recorder’s
built-in clock is also set automatically. The Auto and Manual
clock setting procedures are necessary when . . .
a power outage of more than 3 minutes occurs.
the tuner has been set manually.
the user desires to set the clock slightly ahead of the actual
time.
the clock was not set even after Auto Tuner Set was
performed.
Whether you perform Auto or Manual clock setting, you can
use the convenient Just Clock function.
Just Clock
The Just Clock function provides accurate time keeping through
automatic adjustments at regular intervals, by reading data from
a PDC signal.
The Just Clock option appears in the Just Clock display, and can
be set “ON” or “OFF” (the default setting is “ON”). Press OK
until the Just Clock setting begins blinking, then press PUSH
JOG%fi to change the setting.
IMPORTANT: If you turn off Just Clock off, the accuracy of your
recorder’s built-in clock may be reduced, which could
adversely effect timer recording.
Both Auto and Manual clock setting procedures begin from step
3.
Just Clock Channel Position
TURN THE RECORDER ON
1
Press OPERATE.
ACCESS CLOCK SET
DISPLAY
2
Press CLOCK on the remote control. The Clock Set
display appears.
Preparation
CONTINUED ON NEXT PAGE.
M
D
Minutes
Hour
Year
Month
Day