Filter
Top Products
26 EN
EDITING
Edit To
Another Video
Recorder
You can use your video recorder as the source player and
another video recorder as the recording deck.
MAKE CONNECTIONS
1
Connect the player’s AUDIO/VIDEO OUT connectors
to the recorder’s AUDIO/VIDEO IN connectors.
SET RECORDING DECK’S
INPUT MODE
2
Set the recording deck's external input mode.
START SOURCE PLAYER
3
Press PLAY on the source player.
START RECORDING DECK
4
Engage its Record mode.
NOTES:
●
All necessary cables can be obtained from your dealer.
●
If you do not want to record the superimposed indication on
the editied tape, be sure to set "O.S.D." to "OFF" before you
start editing (
੬
pg. 9).
Another recorder
Recording deck
RF Cable (provided)
VIDEO
CHANNEL
Your recorderSource playerTV Receiver
AV Cable
(not provided)
PLAY
123
456
7
89
0
2
4
1
Remote A/B Code Switching
The remote control is capable of controlling two JVC video recorders independently;
one set to respond to the remote control’s A code control signals and another set to
respond to B code control signals. The remote control is preset to send A code signals
because your video recorder is initially set to respond to A code signals. You can
easily modify your video recorder to respond to B code signals.
1 Unplug the mains power cord from the mains outlet.
2 While holding down VCR on the remote control, press the NUMBER key "2" and
then press STOP.
3 Plug the mains power cord back into the mains outlet.
4 Press
on the remote control. The recorder will now only respond to B code
signals.
NOTES:
●
Some TV sets may malfunction in response to the B code. If this happens, switch
back to the A code.
●
To set the recorder back to respond to A code signals, repeat the same procedure as
shown above except pressing NUMBER key "1" instead of "2" in step 2.
NUMBER "2"
NUMBER "1"
VCR
STOP