Filter
Top Products
9
TV CONNECTION
Connect the satellite receiver (TV Scart socket) to the TV set with a Scart cable. If your TV is stereo, you
can receive the sound in stereo via the Scart connection. Connect the satellite receiver to the video/DVD
recorder with a Scart cable.
INSERTING BATTERIES IN THE REMOTE CONTROL
Remove the cover on the rear of the remote control.
Insert the two batteries supplied into the remote control. Ensure correct polarity of the batteries; the
+ and - markings are indicated inside the battery compartment. Slide the cover back into the housing until it
locks in place.
Connect the RF input on the receiver to the antenna socket or your DVB-T antenna.
Use the antenna cable supplied for this purpose, or a coaxial cable with an IEC standard connector. If the
IEC connector is not yet fi tted to this cable, strip the insulation from the cable as shown in the following
illustration and carefully twist the connector onto the end of the cable until it is securely fi tted to the cable.
RF(HF) CONNECTION
When fi tting the connector, make sure that no strands from the braiding touch the inner
conductor, otherwise a short circuit may occur.
The quality of the reception signal depends on this connection!
CONNECTION AND SETUP
Screw together
Lengthwise slits (3x)
Bend back