Filter
Top Products
11
Preparations
DVF-3070 (EN/E,X,Y)
Connecting to an Audio component
AV receiver or
AV Amplifier
Video cord or S-video cord
Audio cord
Coaxial or Optical cable
(For Europe)
TV
TV
AV receiver or
AV Amplifier
Video cord, S-video cord or Component cords
Audio cord
Coaxial or Optical cable
(For other countries)
1. In case an associated system component is connected, also read the instruction manual of the component.
2. Insert the optical-fiber cable straight into the connector until it clicks.
3. Never bend or bundle the optical-fiber cable.
Notes
Notes
Notes
Connecting to a TV with Component input terminals
(For some areas)
TV
Audio cord
Component cords
System Connections
Select the scanning method of the Component
Video output using the COMPONENT VIDEO
OUTPUT switch on the rear panel.
INTERLACE: Scanning method is fixed at inter-
laced scanning.
PROGRESSIVE: When progressive scanning is
unavailable with certain discs, the scanning
method is switched automatically to interlaced
scanning. When the scanning method is
changed, the scanning status will be displayed
for a few seconds.
[ For some areas ]
Note
Note
Note
When connecting to the S-VIDEO terminal, the SCART terminal, or the COMPONENT VIDEO OUTPUT terminal of this
unit, also connect the composite video cord. In addition, perform the VIDEO OUTPUT setting at the SETUP MENU
screen. ("Select VIDEO OUTPUT"))
When SCART (or COMPONENT) terminal connection is made without connecting the composite video cord and this
unit is set to S-VIDEO, the monitor will not display correctly. (The setting cannot be changed to RGB or COMPONENT)
For playback of DTS audio, please connect an AV receiver or an AV amplifier which can decode DTS by digital con-
nection.
*5357/01-13/EN 03.5.20, 10:24 AM11