Kenwood VR-5700 DVR User Manual


 
51
Using Receiver
Adjusting the brightness of receiver
When the ambient light is low, for example in the night, the brightness of
the receivers display can be dimmed and LED indicators (THX, DTS,
D.R.I.V.E., DOLBY DIGITAL, MPEG, HDCD and 2-way communication
indicator) can be disabled.
Press the F.SHIFT = SOUND (DIMMER)* buttons. Each press of the
SOUND (DIMMER) button switches the brightness as shown below.
1 Display/bright Indicators/enabled
2 Display/dim Indicators/enabled
3 Display/dim Indicators/disabled
Selecting the display mode of receiver front panel
Press and hold the LISTEN MODE (DISPLAY) button on the receiver
for more than 2 seconds.
The displayed information is switched every 2 seconds of holding the
button.
A: Connected Device Input Mode
DVD AUTO
B: Input Terminal Connected Device
VIDEO3 : DVD
C: Listen Mode
DOLBY DIGITAL
"Input Mode" is displayed only when a selector with digital input is se-
lected.
When the selected input is PHONO or TUNER, the connected device and
listen mode are displayed alternately. (Switching between A and C). "Input
mode" and "Connected Device" do not be displayed.
The TUNER display shows the frequency.
How Do I Adjust the LCD Display?
* When an operation is described as [F.SHIFT = SOUND (DIMMER)
button], for example, press the F.SHIFT button and press the next button
(the SOUND (DIMMER) button in this case) within 8 seconds.