Filter
Top Products
1. Remove and save the dome cover screws. (Figs. 6A and 6B).
2. Carefully remove the dome cover, tilting it side to side as necessary to prevent damaging
internal components.
3. Remove and discard the shipping bolt.
Page 6
COMPONENT LOCATION:
1. Select the location of the internal components using the following criteria:
a) The Controller, Tuner, and Power Supply should be in the same general vicinity of
the main satellite receiver, AND ACCESSIBLE FOR OPERATION AND
MAINTENANCE PURPOSES.
b) The Tuner should not be stacked directly on top of other electronics. If located in a
cabinet or other enclosure, make sure there is adequate ventilation around the unit.
(If using the Tuner mounting brackets see page 17.)
c) The Controller should be conveniently located for the end user. (If using the Wall
Mount Faceplate, see page 16.)
d) All components should be secured so they do not shift or bounce around during
vessel motion.
2. Place the components in the selected areas.
SYSTEM LOCATION CHECK
Note: Use appropriate figure for your model number: 9815-RJ = Fig. 6A
9818-RJ = Fig. 6B