Filter
Top Products
Wiring: A send
module (US-P3 or
US-V3) needs to be
connected to a Knoll
receive module (UR-
P3 or UR-V3) to work
correctly. The send
and receive module
are connected using
a single cat 5 wire using all 8 conductors. Connection is made with the
RJ45 connector (RJ45 plug not supplied). Always use standard cat 5
wiring practices. Using the correct wire pairs and polarity is VERY
important.
Connection to stereo video source equipment: Connect the three
US-P3 or US-V3 gold RCA jacks with a good quality gold connector
triple wire component RCA jumper cable to the appropriate three
component output jacks on your DVD, dish receiver, D-VHS, VCR,
stereo or other equipment.
If there is a switched outlet on your output equipment, you may want
to plug the PS1202 power supply to the switched outlet.
Make sure a good quality RJ45 8-8 crimper is used to
connect the RJ45 connector to the cat 5 wire. Poor crimping
and mismatched wires are the biggest cause of installation
problems.
Power requirements: The Knoll balun system requires a single
PS1202 power supply connected to the send unit only. In certain cases
with very long leads a higher voltage PS1506 15 VDC power supply
may be required if wavy or image video lines are evident.
Connection to the Projector, TV or other components: Connect
the three US-P3 or US-V3 gold RCA jacks with a good quality gold
connector triple wire component RCA jumper cable to the appropriate
three component input jacks on your projector, plasma, TV or other
component. Make sure the correct projector, plasma, TV or other
component input is selected.
Multiple Connection(s): If the component signal needs to be sent to
more than one receiver, this can easily be accomplished by daisy
chaining the Knoll component senders. The US-P3 and/or US-V3 sender
RCA inputs need to have their three RCA inputs Y-corded together.
Each sender is connected via one cat 5 wire to one UR-P3 or UR-V3
receiver (as above). Three resistors in all but one of the senders need
to be snipped. For example, if four senders are being Y-corded
together, three (not all four) of the US-P3 and/or US-V3 senders need
to be opened up and have the three 75 ohm through hole resistors
beside the RCA jacks snipped off. Receive units do not have any
alterations. Each send unit requires a PS1202 power supply.
To loop from a local source going to a local component (such as a TV)
using Y-cords, the three 75 ohm resistors in the send unit MAY need to
be snipped.
The Knoll send receive system does not have any user adjustments and
is completely automatic. If need be, please call our tech line for details
at 1 800 566 5579.
This product may contain lead that some states have determined are
harmful. Wash you hands after touching this product.
Decora™ is a trademark of Leviton
CAT 5
UR-V3
Power is supplied
by US-V3
DLP-TV
DVD Player
US-P3
Power supply
gives power
for UR-V3
PS1202