Filter
Top Products
28
Radio Operation
Presetting Radio stations
You can preset 50 stations for FM and AM (MW). Before
tuning, make sure that you have turned down the vol-
ume.
11
Use BAND on the remote control to access FM
or AM (MW) in the display window.
22
Thereafter, each time you press BAND, FM and
AM (MW) change alternately.
33
Press and hold TUNING or on
the front panel for about two seconds until the
frequency indication starts to change, then
release.
Scanning stops when the DVD/CD Receiver tunes in a
station. “TUNED” and “STEREO” (for stereo program)
appear in the display window.
ote
“TUNED” only appears when the signal is FM and
STEREO.
44
Press MEMORY on the front panel.
A preset number will flash in the display window.
55
Press TUNING or on the front
panel to select the preset number you want.
66
Press MEMORY on the front panel again.
The station is stored.
77
Repeat steps 3 to 6 to store other stations.
To tune in a station with a weak signal
Press TUNING or repeatedly in step 3
to tune in the station manually.
To clear all the stored stations
Press and hold MEMORY for about two seconds.
“CLEAR ALL” is appears in the display window, then
press MEMORY again, the stations are cleared.
If you have accidentally entered into the "CLEAR
ALL" mode and you do not wish to clear the memory,
do not press any key. After a few seconds, the
"CLEAR ALL" display will go off by itself and change
to normal mode.
ote
If all stations have already been entered, the FULL
message will appear in the display window for a
moment and then a preset number will flash.
To change the preset number, follow the steps 5-6 as
above.
Listening to the radio
Preset radio stations in the DVD/CD player’s memory
first (see “Presetting radio stations” on the left).
11
Press BAND repeatedly until AM (MW) or FM
appears in the display window.
The last received station is tuned in.
22
Press PRESET +/- repeatedly to select the pre-
set station you want.
Each time you press the button, the DVD/CD player tunes
in one preset station at a time.
33
Adjust the volume by rotating VOLUME on the
front panel or by pressing VOLUME + or - on the
remote control repeatedly.
To turn the radio Off
Press POWER to turn the DVD/CD player off or select
another function mode (CD/DVD or AUX).
To listen to non-preset radio stations
Use manual or automatic tuning in step 2.
For manual tuning, press TUNING or
on the front panel repeatedly.
For automatic tuning, press and hold TUNING
or for about two seconds on the front
panel.
To select a preset radio station directly
You can use the number buttons on the remote control
to select a preset radio station directly.
For example, to listen to preset station 4, press 4 on the
remote control. To listen to preset station 19, press 1
then 9 (within 3 seconds).
For your reference
If a FM program is noisy
Press MONO/ST. repeatedly on the front panel so
that “STEREO” disappears from the display window.
There will be no stereo effect, but the reception will
improve. Press the button again to restore the stereo
effect.
To improve reception
Reorient the supplied antennas.