Filter
Top Products
- 3 -
Description of the appliance
1
Telescopic antennae (VHF/UKW/DVB-T)
2
Oval antenna (UHF)
3
Operation indicator
4
Regulator (amplifier gain)
5
Mains cable
6
Antenna cable
7
Adapter F-Plug/Coaxial socket
8
Adapter Coaxial socket/Coaxial socket
Connection
Connection to a television
➭ Connect the antenna cable of the indoor
antenna „TV“
6
to the antenna jack of your
television set.
Connection as a radio aerial
➭ When you want to use the room antenna for
radio reception, utilise the Adapter Coaxial
socket/Coaxial socket
8
.
➭ Connect the Adapter Coaxial socket/Coaxial
socket
8
with the antenna cable.
➭ Connect the anntenna cable with Adapter
Coaxial socket/Coaxial socket
8
to the
75 Ohm connector on your stereo system.
Connection to a DVB-T receiver
➭ To connect the room antenna to a DVB-T-
Receiver with an F-socket, the Adapter F-Plug/
Coaxial socket
7
must be used.
➭ Connect the Adapter F-Plug/Coaxial socket
7
with the antenna cable.
➭ Screw the antenna cable with the Adapter
F-Plug/Coaxial socket
7
to the F-socket of the
DVB-T-Receivers.
Power source connection
➭ Insert the power plug of the indoor
antenna into the power socket.
Operating the Indoor Antenna
Receiving programme signals via the
indoor antenna
The programme signals are received by the indoor
antenna and transmitted to the television set.
For the reception of DVB-T programme signals you
need an additional DVB-T receiver (DVB-T signals
cannot be received everywhere).
The indoor antenna has to be positioned correctly
for the proper reception of programme signals.
The following antennas are available for this:
1
two telescoping antennas for VHF and UKW
reception that tilt and rotate by 180° and
2
one oval-shaped antenna for UHF reception
that tilts and rotates by 100°.
To orient the indoor antenna:
➭ Pull out both telescopic antenna
1
➭ and adjust these until the best reception is
obtained.
➭ Adjust the oval antenna
2
by turning or tilting
until the best reception is obtained.
Switching On and Regulating the Amplifier
You can regulate the amplifier gain by turning the
regulator
4
on the front of the appliance:
➭ Switch on the indoor antenna by turning the
regulator
4
to the right. The operation
indicator
3
glows green.
➭ Turn the regulator
4
in clockwise direction to
increase the amplifier gain.
➭ Turn the regulator
4
in anti-clockwise direction
to decrease the amplifier gain.
➭ Turn the regulator
4
completely to the left
until it clicks to switch off the indoor antenna.
IB_KH2329_GB_LB3 14.01.2008 15:40 Uhr Seite 3