Filter
Top Products
19
cable until the shutdown has been completed. If
you turn off the main power or disconnect the
power cable before shutdown is complete, data or
user settings may be lost, or you may damage the
hard disk.
Audio that is recorded on the D1600 and the mixer
settings you make are saved automatically when
you select or switch songs, or when you shut
down. However, effects that you edit will be lost
unless you save them.
1 If you wish to keep any effect settings that you
edited, save them. (→p.46)
2 Lower the [MASTER] fader of the D1600 to the –∞
position. Lower the volume of any external
devices to the minimum position.
3 Turn off the power of the external output devices
(such as your monitor system) to which audio is
being sent from the D1600.
4 Press and hold the D1600’s [POWER] key to per-
form the shutdown operation.
When you press and hold the [POWER] key, a dia-
log box will appear, asking you to confirm the
operation. If you press the “Yes” button, the song
will automatically be saved and the D1600 will
shut down and enter standby condition. If you
press the “No” button, you will return to the previ-
ous screen.
5 By pressing the D1600 [Main power] switch to
turn it off, you can turn the power off completely.
6 If an external drive is connected, turn off the
power of the external drive.
7 Turn off the power of external input devices, such
as keyboards.
The D1600 comes with a demo CD that contains demo
songs. Here’s how to listen to the demo songs on the
CD.
This operation requires a separately sold CD-R/
RW drive (such as the CDRW-2).
The included demo CD is different than conven-
tional audio CD’s. Never attempt to use it in an
audio CD player.
1 Connect your CD-R/RW drive.
If you are using an internal CD-R/RW drive, install
the CD-R/RW drive in the CD-R/RW drive bay of
the D1600. (→p.134)
If you are using an external CD-R/RW drive, con-
nect the CD-R/RW drive to the SCSI connector of
the D1600. (→p.67)
2 Restore (load) the demo songs from the demo CD
into the D1600. (→p.66: Backup/Restore)
3 Move the D1600’s [CHANNEL] faders to the 0
mark, and the [MASTER] fader to the –∞ mark.
4 Select the song that you wish to play back.
(→p.22)
5 For each track, make the [TRACK STATUS] key
LED light green. If any LED’s are lit another color,
or are dark, press the corresponding key to make
the LED light green (PLAY).
6 Press the [PLAY] key to begin playback.
7 Slowly raise the [MASTER] fader to adjust the
volume level.
8 When the demo song ends, press the [STOP] key
to stop playback.
Listening to the demo song
Basic operation
Making connections, and
turning the power on/off