Filter
Top Products
Using the PT-1Hs Hs Delay Corrector
5
5 Using the PT-1Hs Hs Delay Corrector
A delayed sync can be corrected by the PT-1Hs when using, for example, the
TP-121 and TP-122 to configure an XGA/Audio Line-to-Twisted Pair Transmitter
and Receiver system.
To connect the PT-1Hs via twisted pair cabling, as the example in
Figure 3
illustrates, do the following:
1. On the TP-121, connect the XGA source (for example, a laptop) to the
XGA INPUT HD15F connector
2
2. On the TP-122, connect
.
2
the XGA OUT HD15F connector to the XGA
IN HD15F connector on the PT-1Hs.
3. On the PT-1Hs, connect the XGA OUT HD15F connector to an acceptor
(for example, a display).
4. Connect the LINE OUTPUT RJ-45 connector on the TP-121 to the LINE
IN RJ-45 connector on the TP-122, via UTP cabling
2
(with a range of
more than 300ft (>100m)).
5. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity on the PT-1Hs and on both
3
6. On the PT-1Hs, adjust
the TP-121
and the TP-122.
4
The signal from the XGA source is transmitted via CAT 5 cable, decoded and
converted at the XGA OUT HD15F connector on the TP-122. The sync delay
is corrected by the PT-1Hs, enabling a “lined-up” image to reach the XGA
acceptor.
the DELAY level, if required.
1 Downgoing syncs
2 Refer to the Kramer TP-120 and TP-121 user manual for installation information
3 If you cannot connect the power to both the TP-121 and TP-122, you can just connect the power to the TP-122
4 Use a screwdriver to carefully rotate the trimmer, adjusting the DELAY level