Filter
Top Products
Connecting Your VP-350 1:3 High Resolution UXGA DA
5
5 Connecting Your VP-350 1:3 High Resolution UXGA DA
To output a UXGA
1
signal from a computer graphics card to three monitors,
as the example in Figure 4 illustrates, do the following:
1. Connect a UXGA
1
source (for example, a computer graphics source) to the
INPUT HD15F connector.
2. Connect the OUTPUT HD15F connectors to up to 3 acceptors, as follows:
Connect the OUTPUT 1 connector to an acceptor (for example,
Display 1)
Connect the OUTPUT 2 connector to an acceptor (for example,
Display 2)
Connect the OUTPUT 3 connector to an acceptor (for example,
Display 3)
3. On the underside of the VP-350:
Set both the Hs and Vs switches to Hi-Z (TTL)
Slide the ID Bit switch to the left to set to ON
Set the RED, BLUE and GREEN COUPLING switches either to DC
or AC, according to the output requirements
4. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.
1 Or any resolution, such as VGA, SVGA, XGA, and so on