Filter
Top Products
Setting up your monitor
This section provides information to help you set up your monitor.
Connecting and turning on your monitor
Note: Be sure to read the Safety Information located in the information flyer
before carrying out this procedure.
1.Power off your computer and all attached devices, and unplug the computer power
cord.
2.Connect the analog signal cable to the D-SUB port on the back of the computer.
Note: One end of the signal cable is already pre-attached to your monitor.
1-4 LT2452pwC Flat Panel Monitor User’s Guide
Cable lock slot
Your monitor is equipped with a cable lock slot located on the rear of your monitor (in
the lower left corner). Please follow the instructions that came with the cable lock to
attach it.