Filter
Top Products
26
PC SETUP
CONNECTIONS & SETUP
CONNECTIONS & SETUP
■
This TV provides Plug and Play capability, meaning that the PC adjusts automatically to the TV's settings.
NOTE
!
To enjoy vivid picture and sound, connect a PC to
the set.
Avoid keeping a fixed image on the set’s screen
for a long period of time. The fixed image may
become permanently imprinted on the screen;
use a screen saver when possible.
Connect PC to the RGB INPUT(PC INPUT) port
of the set; change the resolution output of PC
accordingly.
There might be a noise according to some reso-
lution, vertical pattern, contrast or brightness in
PC mode. Then change the PC mode into other
resolution or change the refresh rate into other
rate or adjust the brightness and contrast on the
menu until the picture is clean. If the refresh rate
of the PC graphic card can not be changed,
change the PC graphic card or consult it to the
manufacturer of the PC graphic card.
The synchronization input form for Horizontal
and Vertical frequencies is separate.
We recommend using 640x480, 60Hz
(42PC1RV
*
, 42PC3RV
*
) /1024x768, 60Hz
(26LC2R
*
, 32LC2R
*
) for the PC mode, they pro-
vide the best picture quality.
If the resolution of PC is over UXGA, there will be
no picture on the set.
Connect the audio cable from the PC to the
Audio input on the set. (Audio cables are not
included with the set).
When you use too long RGB-PC cable, there
might be a noise on the screen. We recommend
using under 5m of the cable. It provides the best
picture quality.
44
55
1
2
3
6
7
8
9
When connecting with a D-sub 15 pin cable
RGB-DTV OUTPUT
REMOTE
CONTROL IN
RS-232C INRS-232C IN
(CONTR(CONTROLOL
&
SERSERVICE)VICE)
HDMI INHDMI IN
AUDIO OUT
VARIABLEARIABLE
RGB INRGB IN
(PC/DTV)(PC/DTV)
AUDIO IN
(RGB)
(R) AUDIO (L)
PC
1
2
Connect the TV to the PC with the PC cable.
Connect the PC audio putput to the TV’s
AAUUDDIIOO IINN
((RRGGBB))
input.
Turn on the PC.
1
2
3
Select RGB input source with using the
IINNPPUUTT
button on
the remote control.
4
0323G_1-en_rev01 2/28/06 4:13 PM Page 26