Filter
Top Products
27
206-4096
Channel Banks Setup
Channel Banks Setup Menu
CHANNEL PREVIEW - BANK 1
CH 011-001 NORMAL-ADDED
Enter -> Change
CC -> VCHIP Menu, Ch. Preview -> Exit
IDs currently selected
channel bank.
IDs currently selected
channel.
IDs channel status in
selected bank.
Channel Status Options
• Normal-Added: Channel will appear
in channel scan.
• Normal-Deleted
: Channel will not
appear in channel scan.
• Blank-Added: Channel will appear in
all channel banks, video will be black,
no picture.
• Blank-Deleted: Channel will be
blanked in all channel banks.
Select a channel bank using the INPUT or BANK button on your Installer Remote. After the desired bank is
selected, press CH PREVIEW to display the Channel Banks Setup Menu.
Channel Status Options for Channel Banks
In the Channel Banks Setup Menu, use the Channel Up/Down arrows to go to a channel and the Left/
Right arrows to select the channel status. See also sample channel status charts on the following page.
Adding / Deleting / Blanking Channels
It is best to do ADD / DEL customizing before doing “BLANK.” Auto Tuning (channel search) enters the same
channel numbers in Channel Banks 1, 2, 3, and 4. Auto Tuning also removes any channels previously custom-
ized with ADD / DEL / BLANK. All channels found in the channel search will be included, and any channels
previously found but not currently available will not be included. ADD and DEL (not BLANK) can be used inde-
pendently for Channel Banks 1, 2, 3, and 4. (If a channel was not found in the channel search [and was not
added during the Commercial Mode Setup/Express Script procedures], it can be added using the Manual
Tuning option in the Channel Menu.)
Note: A channel blanked, is blanked in all channel banks.
Selecting Deleted Channels
To tune to a Normal-Deleted channel, either:
• Select a channel bank where the channel is added.
• Direct enter the channel number. Then, go to the bank where the channel is set as “Normal-Deleted,” and
reconfigure the channel status.
Note: Installer Menu item 028 CH. OVERIDE must be set to 001 to allow access to the channel scan.
Channel allocations in tuning bands:
• Broadcast and Broadcast Digital: 2 - 69
• CABLE - CATV, HRC or ICC: 1 - 125
Inactive TV Setup
To create an inactive TV display on Channel Bank 4, select Normal-Deleted for each channel in Channel
Bank 4. When the TV is powered On by the patient, the “Inactive TV Call Attendant” message will appear on
the screen, and after a few moments the TV will turn itself Off. This will prompt the patient to arrange for an
available programming package on Channel Bank 1, 2, or 3. Using the Installer Remote, the administrator can
activate Channel Bank 1, 2, or 3 depending on the entertainment programming tier selected by the patient.
When the patient leaves the hospital, the administrator can then select Channel Bank 4 to reinstate the
“Inactive TV” message.