Filter
Top Products
5-4. Raster H-center(H.CENTER) Adjustment
Select 77. H Postion in the adjustment mode and adjust until
left and right screen are symmetrically equal.
5-5. Horizontal Deflection Size Adjustment
(1) Reduce 66 H-Size to verify screen protection (overscan)
on the right and left sides.
(2) Adjust the horizontal size, using a test pattern.
5-6. Horizontal Pincushion Adjustment
(1) Select EZ Adjust 2. Pin-Cushion by pressing the ADJ key
on the SVC Remote control.
(2) Select PIN-PHASE, PIN-AMP, AFC-BOW, AFC-ANGLE,
UP-CPIN, LO-CPIN in the adjustment mode and adjust
until there is no Pincushion distortion or trapezoid
distortion on the screen.
6. Component AD9883A Offset/Gain
Adjustment
6-1. Test equipment
(1) SVC Remote Control,
(2) 801GF(802B, 802F, 802R) pattern generator
6-2. Preliminary Steps
(1) Turn the power supply on.
(2) Enter the Component mode.
(3) Receive the 1080I, Hoz30Bar Pattern of the 801GF.
6-3. ADC Offset Adjustment
(1) After receiving a signal press the ADJ Key on the SVC
Remote Control repeatedly to acess the Adjustment mode.
(2) #9. Set Adjustment will set the AD9883A automatically.
7. White Balance Adjustment
Perform the screen adjustment first.
Color Temp must be adjusted from Medium Mode.
(The image condition must be adjusted from Normal condition)
Manual adjustment is also possible by the following sequence.
(1) Receive White Pattern.
(2) Set screen size to wide mode
(3) Select EZ Adjust 4. White Balance on the SVC Remote
control.
(4) Adjustment
1. Set an image with Normal image.
2. Adjust R-DRIVE and B-DRIVE data so the color
coordinates in High light are the values in Table below.
(bright level : 25Ft_L)
3. Adjust “CONTRAST” and “BRIGHT” so the bright level is
4.5±0.5Ft_L.
4. Adjust R-CUT and B-CUT data so the color coordinates
in Low light are the values in Table below.
5. Repeat 1 ~ 4 until the color coordinates in High and Low
color satisfies the Table.
6. Check the adjusted color coordinates with the white
balance meter.
High Light : x=287
!
3, y=293
!
3
Low Light : x=287
!
3, y=293
!
3
Color temperature : 9,000K!
1000(-5MPCD)
[ The White Balance it executes from automatic adjustment
hour Normal image condition.
Start adjustments from initial setting of R.DRIVE=31,
G.DRIVE=31, B.DRIVE=31, R.CUT=31, G.CUT=31,
B.CUT=31.
8. Sub Bright, TINT, COLOR Adjustment
8-1. Sub Bright Adjustment
- 11 -
ADJUSTMENT INSTRUCTIONS
<1080I Hoz30Bar Pattern>
0 123 4 5 76 8 9
US14CH