Filter
Top Products
15
206-4186
Installer Menu
Typical Installer Menu
Use the Installer Menu to set up or change operational settings.
Refer to the table starting on the next page for brief descriptions of Installer Menu items.
More detailed descriptions follow the table listing.
xxLD340H PTC INSTALLER MENU
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC 20E7
PTC V1.00.001 CPU V3.25.00
Accessing the Installer Menu
1. Make sure the TV is ON.
2. Using an Installer Remote, press MENU repeatedly until the on-
screen display of the TV setup menus (if the TV is in Pass-through
Mode) or the Function Menu (if the TV is not in Pass-through Mode)
no longer toggles, and then press 9-8-7-6 + ENTER to access the
Installer Menu.
The Installer Menu opens with item 000 INSTALLER SEQ 000.
Note: If the password is not entered or registered correctly, you will see
the message “ENTER PASSWORD 0000” at the top of the screen instead
of the Installer Menu header. Once you re-enter the correct password
(i.e., press 9-8-7-6 + ENTER), the Installer Menu will display.
Note: If the TV is in FTG Mode, the Installer Menu is accessible as read-
only. Refer to pages 30 to 40 for information on FTG Mode configuration.
Using the Installer Menu
Refer to the table on pages 16 and 17 for an overview of the available Installer Menu items,
including their item numbers, functions, value ranges, and default values. Installer Menu items
not relevant to this TV series are not present in the Installer Menu; therefore, some numbers are
missing. For example, item 006 will not appear.
Navigation within the Installer Menu
Use the Up/Down arrow keys on the Installer Remote to sequence through the available menu
items, or access an item directly by keying in the line number and then pressing MENU. For
example, to access the SLEEP TIMER option, which is item 015, press 0-1-5 + MENU.
Changing Installer Menu Settings
To change an Installer Menu item value, use the Left/Right arrow keys on the Installer Remote,
or enter a valid value directly. To save the new setting, press ENTER, or use the Up/Down
arrow keys to navigate to a new Installer Menu item if you have additional items to edit. Note
that invalid values will not be saved.
Exiting the Installer Menu and Activating Updates
After you have adjusted all required Installer Menu item settings, press ENTER once on the
Installer Remote to save your changes; then, press ENTER again to exit the Installer Menu. Any
changes you make will be stored in non-volatile memory.
Note: Each time you exit the Installer Menu in Pass-through Mode, all V-Chip (Parental Control)
settings in the TV are reset to their default values; that is, the Lock System, if previously enabled
from the Lock setup menu (see the Owner’s Manual for additional information), will now be
disabled, and the individual Parental Control settings will be restored to default values.