LG Electronics 32LD325H CRT Television User Manual


 
23
206-4186
Cloning Overview
IMPORTANT CLONING INFORMATION
There are three different procedures for cloning a Master TV Setup, each with its own advantages and
limitations (see also “Cloning Methods” on page 11):
• Using a USB memory device
• Using a TLL-1100A clone programmer
• Using a LT2002 clone programmer
Each cloning method is described in further detail on the pages that follow. As you perform cloning
procedures, be sure to complete each task as indicated. If a procedure or step is omitted or not
performed completely, cloning may not work. At each step, pay attention to ensure the TV screen shows
the proper message when cloning. If the message indicated does not appear, there is a problem with that
step, and cloning may not be successful.
Caution: Copying a blank or incorrect memory into a TV from a clone programmer will
cause the TV to operate erratically or become inoperable.
Caution: Do not connect a clone programmer to a PPV card installed in the Master or
Target TVs. Also, if the TV is in LodgeNet PPV Mode (check with the site administrator if
you are not certain), do not connect a clone programmer to the GAME CONTROL/MPI port.
Either of these actions will damage the clone programmer and, if applicable, the PPV card.
Before you begin cloning:
• Complete the Master TV Setup procedure (see pages 11 to 14).
• All equipment should be connected to power and turned ON.
• Both the Master and Target TVs must be in Pass-through Mode.
• Learning and Teaching is only possible between identical model TVs.
• If using a USB memory device, ensure the USB device has been formatted with FAT format.
• For both Master and Target TVs—If using a clone programmer, ensure the TV is tuned to either an Aux
input or an analog (not a digital) channel.
• LT2002 only—Make sure the batteries in the clone programmer are fresh. If batteries are removed, the
clone programmer clock time (if set) will be lost (see page 29 for information on the clone programmer
clock).
Caution: Do not unplug the TV power cord or remove/disconnect the USB memory device/
clone programmer while Learning or Teaching, as doing so may cause the TV to malfunction
or harm the USB device/clone programmer, respectively.