Filter
Top Products
36
ENGLISH
EXTERNAL CONTROL DEVICE SETUP
Data03
00: Right to Left
01: Left to Right
Data04
3D Depth: Min : 00 ~ Max : 14
(*transmit by Hexadecimal code)
*If data01 is 00(3D On), data04 has no
meaning.
*If data01 is 01(3D Off) or 02(3D to 2D),
data02, data03 and data04 have no meaning.
*If data01 is 03(2D to 3D), data02 has no
meaning.
Data 01 Data 02 Data 03 Data 04
00 o o x
01 x x x
02 x x x
03 x o o
x : Don’t care
Acknowledgement [t][ ][OK][Data01][Data02]
[Data03][Data04][x][t][ ][NG][Data01][x]
16. Color Temperature (Command: x u)
To adjust color temperature.
You can also adjust color temperature in the
PICTURE menu.
Transmission [x][u][ ][Set ID][ ][Data][Cr]
Data Min: 00 ~ Max: 64 (*transmit by
Hexadecimal code)
*Refer to Real data mapping.
Acknowledgement [u][ ][Set ID][ ][OK/NG][Data]
[x]
17. Extended 3D (Command: x v) (For 3D TV)
To change 3D option for TV.
Transmission [x][v][ ][Set ID][ ][Data01][ ]
[Data02][Cr]
Data01: 3D option
00: 3D Picture Correction
01: 3D Depth (2D to 3D Only)
02: 3D Viewpoint
03: 3D Picture Size
04: 3D Picture Balance
05: 3D Optimization
Data02: It has own range for each 3D option
determined by Data01.
1) When Data01 is 00
00: Right to Left 01: Left to Right
2) When Data01 is 01, 02
Data Min: 00 ~ Max: 14 (*transmit by
Hexadecimal code)
3) When Data01 is 03
00: Just Scan 01: 16:9
4) When Data01 is 04
00: Off 01: On
5) When Data01 is 05
Data Min: 00 ~ Max: 02 (*transmit by
Hexadecimal code)
Acknowledgement [v][ ][OK][Data01][Data02][x]
[v][ ][NG][Data01][x]
* Use the feature depending upon your model.
18. Auto Configuration (Command: j u)
To adjust picture position and minimize image
shaking automatically. Auto configuration only
works in RGB-PC mode.
Transmission [ j ][u][ ][Set ID][ ][Data][Cr]
Data 01: To set
Acknowledgement [u][ ][Set ID][ ][OK/NG][Data]
[x]
19. Channel Tuning (Command: m a)
To tune channel to following physical/major/
minor number.
Transmission [m][a][ ][Set ID][ ][Data00][ ]
[Data01]
[ ][Data02][ ][Data03][ ][Data04][ ][Data05][Cr]
Digital channels have a Physical, Major, and
Minor channel number. The Physical number is
the actual digital channel number, the Major is
the number that the channel should be mapped
to, and the Minor is the sub-channel. Since the
ATSC tuner automatically maps the channel to
the Major number, the Physical number is not
required when sending a command.
Data 00: Physical Channel Number
NTSC air: 02~45, NTSC cable: 01, 0E~7D
ATSC air: 01~45, ATSC cable: 01~87