Filter
Top Products
41
206-4213
1. Turn ON the TV, and then plug the USB memory device that
contains the FTG Conguration le into the Target LT670H or
LS675H TV USB IN port.
2. Press MENU SETTINGS on the Installer Remote to display the TV
setup menus (TV is in Pass-through Mode) or the Function Menu
(TV is already in FTG Mode).
3. Use the arrow navigation keys to select/highlight either the Option
menu icon from the TV setup menus or the Lock menu icon from the
Function Menu. Then, press the number “7” key a total of seven times
to display the USB Download Menu.
4. Use the Up/Down arrow keys to select Teach To TV (TLX), and then
press OK.
5. Use the Up/Down arrow keys to select the FTG Conguration le
you want to install, and then press OK.
Teaching status will be shown on a progress bar in a new window.
Do NOT remove the USB device until Teaching is complete. When the
Teaching process is complete, the TV will briey display a “Teaching
Completed” window and then exit the USB Download Menu.
6. Remove the USB memory device from the Target TV, and verify that
the FTG Configuration is resident on the Target TV.
The Target TV CPU is now in FTG Mode (if it was previously in Pass-
through Mode).
Note: After the Teaching process is complete, the TV tunes according
to the Start Channel setting in the Installer Menu. If a Start Channel is
specied, the TV will tune to that channel; otherwise, the TV will tune to
the lowest logical channel in the FTG Channel Map.
Teaching FTG Conguration to a TV
This section describes how to “Teach” an FTG Conguration le from a USB memory device to a TV.
Ensure you have completed the procedure on the previous page to create the FTG Conguration le
before proceeding with the steps below.
Notes: • If the TV EBL is already in FTG Mode, you cannot use this procedure to make changes to
the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV
connection as described on page 44 or an FMA head end device to recongure the EBL.
• If the preceding condition applies, but you wish to switch the TV to FTG mode via CPU,
refer to Reference section, “Restoring Factory Defaults on the TV(s),” for further information
before proceeding.
• If the Automated Installation Routine Wizard appears on the screen when you turn ON the
TV, you can use the “USB Conguration” option to congure this TV, if desired (see “USB
Conguration” on page 13).
FTG Mode via CPU (Cont.)
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV (TLL)
Teach To TV (TLX)
Previous OK
Teach To TV (TLX)
Previous OK
xxLT670H-UA00005.TLX
UPDATING...
Do not unplug!
50%
Teach To TV