Filter
Top Products
16 Plasma TV
Installation
- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
- This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
How to connect
Use the TV’s COMPONENT (Y, P
B, PR) INPUT, RGB or HDMI/DVI jack
for video connections, depending on your set-top box connector. Then,
make the corresponding audio connections.
How to use
1. Turn on the digital set-top box. (Refer to the owner’s manual for the
digital set-top box.)
2. Use TV/VIDEO on the remote control to select Component 1,
Component 2, RGB-DTV, or HDMI/DVI source.
HDSTB Setup
HDSTB Setup
DIGITAL AUDIO
OPTICAL OUTPUT
(CONTROL/SERVICE)
RS-232C INPUT
REMOTE
CONTROL
AC INPUT
RGB INPUT
(R) AUDIO (L)
DVI-DTV OUTPUT
DIGITAL AUDIO
OPTICAL
HDMI-DTV OUTPUT
HDMI /DVI
INPUT
(VIDEO)
RGB/DVI AUDIO
INPUT
Digital Set-top Box
or
Signal
480i
480p
720p
1080i
Component 1/2
Yes
Yes
Yes
Yes
RGB-DTV , HDMI/DVI
No
Yes
Yes
Yes
or
REMOTE
CONTROL
AC INPUT
RGB INPUT
(R) AUDIO (L)
RGB-DTV OUTPUT
AUDIO
R
L
VIDEO
COMPONENT INPUT 1
DVD
/DTV
INPUT
COMPONENT INPUT 2
B
R
(R) AUDIO (L)
DIGITAL AUDIO
OPTICAL
RGB / DVI
INPUT
AUDIO