Filter
Top Products
11
ENGLISH
CAUTION
Do not mix old and new batteries, as this may
damage the remote control.
A
A
(POWER) Turns the TV on or off.
(INPUT) Changes the input source.
Number buttons Enters numbers.
(DASH) Inserts a dash between numbers such as
2-1 and 2-2.
Accesses the saved channel list.
Views the information of the current channels
and screen.
B
C
B
Adjusts the volume level.
(MUTE) Mutes all sounds.
* By pressing and holding the button, video
descriptions function will be enabled.
* (Secondary Audio Program) Feature can also
be enabled by pressing the key.
Scrolls through the saved channels.
(Home) Accesses the Home menu.
(BACK) Returns to the previous screen.
Clears all on-screen displays and returns to TV
viewing.
C
Wheel (OK) Press the center of the Wheel button
to select a menu. You can change channels by using
the Wheel button.
(up/down/left/right) Press the up, down,
left or right button to scroll the menu. If you press
I
n PC mode, there may be noise associated
with the resolution, vertical pattern, contrast
or brightness. If noise is present, change the PC
output to another resolution, change the refresh
rate to another rate or adjust the brightness and
contrast on the PICTURE menu until the picture is
clear.
Depending upon the graphics card, some
resolution settings may not allow the image to be
positioned on the screen properly.
Connecting to an Antenna or Cable
Connect an antenna, cable, or cable box to watch
TV. The RF cable may not be supplied, depending
upon the model.
CAUTION
Make sure not to bend the copper wire of the RF
cable.
Copper wire
Complete all connections between devices, and
then connect the power cord to the power outlet
to prevent damage to your TV.
NOTE
Use a signal splitter to use 2 TVs or more.
DTV Audio Supported Codec: MPEG, Dolby
Digital.
Other Connections
Connect your TV to external devices. For the best
picture and audio quality, connect the external
device and the TV with the HDMI cable. Depending
upon the model, a cable may not be provided.
Magic Remote Functions
When the message
Magic remote control battery
is low. Change the battery.
is displayed, replace the
battery. To install batteries, open the battery cover,
replace batteries (1.5 V AA) matching and ends
to the label inside the compartment, and close the
battery cover. Failure to match the correct polarities
of the battery may cause the battery to burst or leak,
resulting in fire, personal injury, or ambient pollution.
Be sure to point the remote control at the remote
control sensor on the TV. To remove the batteries,
perform the installation actions in reverse.
This remote uses infrared light. When in use, it
should be pointed in the direction of the TV’s
remote sensor.