Filter
Top Products
98 DLP Projection TV
Troubleshooting Checklist
T
T
roubleshooting Checklist
roubleshooting Checklist
I set a show to Auto-Tune
and it did not.
• Check the Schedule menu and verify that the show is listed as a Reminder.
• Highlight the show under Listings and do the following:
W
Press the Menu key on the remote.
W
Use the down arrow to highlight Edit Reminder, and press ENTER.
W
Verify the Auto-Tune option reads Yes.
• The TV must be On at the scheduled time for Auto-Tune.
• If you have a cable box, check the IR cable.
I set a show with the
Power On TV option and
it did not.
• Check the Schedule menu and verify that the show is listed as a Reminder.
• Highlight the show under Listings and do the following:
W
Press the Menu key on the remote.
W
Use the down arrow to highlight Edit Reminder, and press ENTER.
W
Verify the Power On TV option reads Yes.
A show I set to Record
did not occur.
• Make sure your recorder is turned Off before the recording begins.
• Make sure there is a tape.
• Check the Schedule menu and verify that the show is listed before recording
begins.
• Check the placement of the IR cable in front of your recorder.
I have not received any
Guide listings.
• Listings usually appear within 24 hours after a successful Setup.
• It may take up to a week to fill the Listings grid with the full 8 days of listings.
• If you see a Listings grid with the message "No Listings" displayed you should
start to receive updated program listings within 24 hours. To receive listings:
W
Make sure the cable box is left On, if applicable.
W
Turn off your recorder when not in use.
• If the message "No data for this screen" is displayed:
W
Check the connections between the TV, cable, antenna, and the IR cable
if using a cable box.
W
Verify Setup information under Change System Settings.
W
Make sure the cable box is On, if applicable.
W
If this message is still displayed after multiple days, please contact the
LG® Brand Customer Support.
Some channel numbers
in the Guide are incor-
rect.
• You can correct them using Change Channel Display under Setup.