Filter
Top Products
9
Introduction
Audio Connection to Optional Equipment
Connect the DVD player to your optional equipment for audio output.
Amplifier equipped with 2-channel analog stereo or Dolby Pro Logic
ll / Pro Logic: Connect the left and right AUDIO OUT jacks on the DVD
player to the audio left and right IN jacks on your amplifier, receiver, or
stereo system, using the audio cables (A).
Amplifier equipped with 2-channel digital stereo (PCM) or audio /
video receiver equipped with a multi-channel decoder (Dolby
Digital™, MPEG 2, or DTS): Connect one of the DVD Player’s
DIGITALAUDIO OUT jacks (COAXIAL X) to the corresponding in
jack on your amplifier. Use an optional digital (coaxial X) audio cable.
Digital Multi-channel sound
A digital multi-channel connection provides the best sound quality.
For this you need a multi-channel audio / video receiver that supports
one or more of the audio formats supported by your DVD player such as
MPEG 2, Dolby Digital and DTS. Check the receiver manual and the
logos on the front of the receiver.
NOTES
• If the audio format of the digital output does not match the capabilities of your
receiver, the receiver produces a strong, distorted sound or no sound at all.
• Six Channel Digital Surround Sound via a digital connection can only be
obtained if your receiver is equipped with a Digital Multi-channel decoder.
•To see the audio format of the current DVD in the on-screen display, press
AUDIO.
Setting up the Player (continued)
R
L
AUDIO INPUTDIGITAL INPUT
COAXIAL
Amplifier (Receiver)
Rear of DVD player
AX