Filter
Top Products
PAGE 27
PIP (Picture-in-Picture) Operation
Press PIP on the remote control with the
PIP image on the screen to activate POP
(Picture-out-of-Picture) mode.
The pictures of all the programmed chan-
nels are searched with the 3 PIP screen, as
shown to the right.
• Press SWAP, to enlarge the selected
channel being searched on the PIP
screen to view it on the Main screen.
(Main and sub pictures can be swapped
if main picture source is Ant/Cable.)
Press the EXIT button to exit POP mode.
1
2
POP (Picture-out-of-Picture)
1
2
Use POP to search the pictures of all the programmed chan-
nels one-by-one on the 3 PIP screen display, while the main
screen remains the current channel.
Press the SWAP button.
Each time you press the SWAP button, you switch the Main and PIP pictures.
In the PIP mode, each press of the UP/DOWN/LEFT/RIGHT arrow buttons will
move the sub picture to a different position on the screen.
Select the Ant/Cable source with the PIP INPUT button.
Use the PIPCH-/PIPCH+ button to select a channel for the sub picture.
Main Picture Sub Picture
Run EZ Scan channel search before using POP mode.
Selecting PIP Channels
Swapping Pictures
Moving the Sub Picture