LG Electronics LST-3100A Flat Panel Television User Manual


 
18
Setup Menu Options
EZ Scan (Channel Search)
Automatically finds all channels (digital) available using the ‘Ant In’ source,
and stores all the active channels found on the channel list. Inactive or weak
channels may not appear on the list. In that case, add missing channels
manually with the Manual Add menu. The channel list created here can be
seen in the Ch. Edit menu.
1
Press MENU to display the on-screen menu.
2
Select the SETUP menu using
3
/
4
then press (SELECT) or
2
to
move to the second level.
3
Select the EZ Scan using
3
/
4
then press (SELECT) or
2
.
ote
If the Lock System is set to On, a password is required to gain access to the
EZ Scan menu. Follow step 2 as shown for the Lock System on page 28.
4
Select the signal source (DTV or CADTV).
DTV is for over-the-air antenna reception.
CADTV is for cable subscribers.
otes
If you select CADTV, select a cable band (STD, HRC, or IRC). Ask your
cable service provider about cable band.
In most cases you can search channels correctly by selecting STD cable
band. Try the other bands if you cannot find any channels.
Some scrambled channels may not be stored.
5
Press (SELECT).
The channel search process begins. You can stop the process by press-
ing (SELECT), MENU or EXIT.
6
When channel search is complete, the lowest channel number
found appears on the TV screen.
EZ Add
Automatically adds new channels (digital) available through the antenna
inputs except memorized channels already in the channel list.
1
Press MENU to display the on-screen menu.
2
Select the SETUP menu using
3
/
4
then press (SELECT) or
2
to
move to the second level.
3
Select the EZ Add using
3
/
4
then press (SELECT) or
2
.
EZ Add channel search process begins. You can stop the process by
pressing (SELECT), MENU or EXIT.
4
When EZ Add channel search is complete, the lowest channel num-
ber found appears on the TV screen.
ip
You can also start EZ Add channel search by pressing ez ADD then
(SELECT) button on the remote control.
TV/INPUT
AUDIO CC SIGNAL
ez ADD
*
ez ADD button