Filter
Top Products
Owner’s Manual 15
Operation
Turning on the Monitor just after installation
Turning on the Monitor (power cord is still connected)
1. Connect power cord correctly.
- A inactive menu options aren’t available in this monitor.
It’s only available to connect with PDP Tuner (RP-BA50).
2. Press the ON/OFF button on the Monitor. At this moment, the Monitor is switched to standby
mode. Press the INPUT SELECT button on the Monitor or press the POWER, INPUT SELECT,
MULTIMEDIA button on the remote control to switch the Monitor on.
• Press the ON/OFF button on the Monitor to turn the Monitor on.
1. If the Monitor was turned off with the ON/OFF button on the Monitor
2. If the Monitor was turned off with the remote control and the ON/OFF button on the Monitor
• Press the ON/OFF button on the Monitor and then press the INPUT SELECT button on the
Monitor. Or, on the remote control, press POWER, INPUT SELECT, or MULTIMEDIA to turn the
Monitor on.
- The menus can be shown on the screen in the selected language. First select your language.
1. Press the MENU button and then use
D
/
E
button to select the SPECIAL menu.
2. Press the G button and then use
D
/
E
button to select Language.
3. Press the G button and then use
D
/
E
button to select your desired language.
From this point on, the on-screen menus will be shown in the language of your
choice.
4. Press the ENTER button to save.
SPECIAL
Prev.
Language G
Key lock
ISM Method
Low power
Set ID
Caption / Text
Captions
OSD Rotate
English
Español
Português
Français
SPECIAL
MENU
Operation
Operation
Menu Language Selection
Menu Language Selection
T
T
urning on the Monitor
urning on the Monitor