Filter
Top Products
16 Plasma TV
Operation
How to connect
1. To get the best picture quality, adjust the PC
graphics card to (RU-42PZ61->1024x768, RU-
42PZ71->852x480, RU-50/60PZ61->1366x768),
60Hz.
2. Use the TV’s RGB INPUT or DVI (Digital Visual
Interface) INPUT port for video connections,
depending on your PC connector.
• If the graphic card on the PC does not output
analog and digital RGB simultaneously, connect
only one of either RGB INPUT or DVI INPUT to
display the PC on the TV.
• If the graphic card on the PC does output analog
and digital RGB simultaneously, set the TV to
either RGB or DVI; (the other mode is set to Plug
and Play automatically by the TV.)
3. Then, make the corresponding audio connection. If
using a sound card, adjust the PC sound as
required.
How to use
1. Turn on the PC and the TV.
2. Turn on the display by pressing the POWER button on the TV's remote control.
3. Use TV/VIDEO or MULTIMEDIA on the remote control to select RGB, or DVI source.
4. Check the image on your TV. There may be noise associated with the resolution, vertical pattern, contrast or brightness in PC
mode. If noise is present, change the PC mode to another resolution, change the refresh rate to another rate or adjust the
brightness and contrast on the menu until the picture is clear. If the refresh rate of the PC graphic card can not be changed,
change the PC graphic card or consult the manufacturer of the PC graphic card.
NOTES: • Use a DVI cable.
• Avoid keeping a fixed image on the TV's screen for a long period of time. The fixed image may become permanently
imprinted on the screen. Use the Orbiter screen saver when possible.
• The synchronization input form for Horizontal and Vertical frequencies is separate.
PC Setup
PC Setup
RGB INPUT
AUDIO INPUT
DVI INPUT
REMOTE
CONTROL
R
EXTERNAL SPEAKER
R
L
RS-232C INPUT
(CONTROL/SERVICE)
AUDIOVIDEO
COMPONENT
INPUT 2
COMPONENT
INPUT 1
MONI
OUT
A/
INPU
(R) (L)
AUDIO
VIDEO
(L/MONO)
(R)